Craftex CX704 Manuel d'utilisateur télécharger pdf (Page 9)

9

HAND WHEEL HANDLES

Thread the handles into the longitudinal and

tailstock handwheels and tighten using a

screw driver and an open wrench. See

figure-2 & 3.

Figure-2 Installing the tailstock hand wheel

handle

Figure-3 Installing longitudinal hand wheel

handle

The cross slide feed handle comes installed

with the opposite direction for shipping

purposes. Remove the cap srew using a

hex wrench and turn the handle around.

Secure the handle by retightening the cap

screw. See figure-4.

Figure-4 Installing the cross feed hand

wheel handle

BASIC CONTROLS

This section describes the basic controls of

the CX704. Use the figure and read the

descriptions to understand the basic

controls of this lathe.

Figure-5 Control panel

A. FUSE SOCKET: Features a 5 Amp

system fuse.

B. VARIABLE SPEED CONTROL KNOB:

Controls the spindle speed range from 0 -

2500 RPM.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Commentaires sur ces manuels

Pas de commentaire